UniBond 2-part adhesive
Under 18 yearsDiscontinued
Unfortunately, we no longer stock this item
Product details
Product information
2 component adhesive ideal for bonding, repairing, fixing and replacing most materials
- Suitable for Ceramics, glass, metal, plastic & wood
- For best results, lightly sand surfaces prior to bonding. Make sure surfaces are clean, dry and completely free from dust, dirt, rust, oil, grease, polish and moisture. Remove re-sealable cap and instant mix nozzle by sliding towards tip of syringe. Snap off and discard tab from tip of syringe nozzles. Push instant mix nozzle onto the syringe past the prongs. Rotate 90° anti-clockwise to lock in place 4) Push down syringe plunger slowly until the Instant mix nozzle is full of adhesive. Apply adhesive directly to one surface to be bonded. Push both surfaces together firmly. Remove as much excess adhesive as possible using methylated spirit. Adhesive is workable for approx. 3 minutes and will set in 5 minutes at 23°C. Use self adhesive tape or clamps to hold bond in position for at least 15 minutes. Allow 1 hour before rough handling.
Features and benefits
- Does not shrink or expand on curing
- It is recommended to store in cool dry condition within a syringe
Health and safety
Please note that this item has additional safety or regulatory datasheets available. The product may have possible health and safety hazards covered in these documents. Refer to the container for full information and always follow the instructions.
DetailsSpecifications
| Product code | 5010383505370 |
|---|
Reviews
1.66 / 5(6 reviews)Mholme58 - 1 / 5 - 19/06/2020
Utter garbage
This should be renamed 'Udon'tbond - poxy glue' Didn't set properly. Was still tacky after 48hrs. Waste of money. Bought another resin tube for £1 - worked perfectly.
Davidnc - 1 / 5 - 05/05/2020
Rubbish
Don’t waste your money, nowhere near a string permanent bond.
midlifecrisis - 5 / 5 - 03/12/2019
It worked for us!
We used this product in an industrial context to bond studs to machinery in an outdoor, seaside environment. Unlike the previous epoxy, which was subject to salt attack and failed within 6 months. this has stood the test of time. We had no issues using the product.
RobEv - 1 / 5 - 25/11/2019
Please don't waste your money !
Unfortunately I didn't read the reviews before I bought this product. If I had then I would have purchased a different one. Previous reviews are absolutely correct. It's rubbish and simply doesn't work. I didn't find it difficult to assemble the tube but it simply didn't set and after leaving for 24 hours the parts I was gluing fell apart when I removed the tape holding them together. I'm going to try and get a refund for this product not being as described but I don't hold out much hope. Absolute Rubbish !
Davidsw - 1 / 5 - 12/10/2019
Terrible
Bad instructions very difficult to get glue from tube When eventually managed to get some out it didn’t set . Don’t waste your time and money . I would leave no stars if I could
Nedwick - 1 / 5 - 29/08/2019
NEVER, EVER USE THIS PRODUCT
I have used epoxy glue for many years, but never had an experience like this. The instructions are not clear, but you can basically work it out. The nozzle became clogged very quickly and glue came out all over the place - except from the end of the nozzle where it is supposed to come out. The glue was too viscous to accurately spread. If you absolutely must use this, lay down a dust sheet and keep it away from anything of value - oh and wear rubbish clothes as they are likely to be ruined. This is the worst disign of anything I have used since the chocolate teapot.