B&Q Shower riser kit
Product details
Product information
This B&Q easy plumb pack has been designed to make your shower tray installation as simple as possible. Installing your shower tray on the legs provided makes levelling the tray simple, as well as providing easy access to plumbing and waste pipes. The versatile seal strip creates a 'tiling upstand' to give a better seal when tiling, along with the universal panels to finish. It is compatible with all B&Q resinlite and cast stone classic trays.
- Comes with Front and side panels, 2 versatile seal strips, 3 corner/end brackets and 2 panel joining brackets, 8 circular base plates and adhesive pads, a pack of 8 adjustable feet and 6 panel upright brackets with magnetic strips
Features and benefits
- Suitable for use with any ResinLite and cast stone classic tray
- Waste sold separately - Requires B&Q high flow waste
- Installation is further simplified with B&Q extendable flexi pipe
Specifications
| Pack quantity | 1 |
|---|---|
| Product code | 03772485 |
Reviews
2 / 5(5 reviews)no 1 - 1 / 5 - 08/05/2017
If I dont mark the review boxs it will not send
The tray dose not fit this Universal plum tray has a soft polstyrene bottom not compatible
Jimmym20001 - 1 / 5 - 14/09/2016
Shower Riser Kit - Total rubbish
I bought this as I needed to lift my shower tray. Legs were fine, but the plastic edging strip/cover is flimsy plastic connected to the legs via velcro! It has completely ruined the shower enclosure. Note: its also a different colour to the white shower trays you buy at B&Q! AVOID!!!
AnyNickNameNotAlreadyUse - 1 / 5 - 20/08/2016
Flimsy, good only as a set of decor panels
Used this with a Cooke and Lewis Exuberance 900mm quadrant base - the legs in this kit do NOT provide adequate support for the shower tray, even though all legs were adjusted to make correct contact with the floor. The tray was visibly flexing when I walked on it, which will make a good seal to the walls impossible. The tray instructions talk of mounting it on a marine ply base board if you want a raised installation (as I do), whereas this kit says to space the legs out evenly and stick them on direct to the base - bad idea, I bitterly regret not going down the plywood route, in fact once I get the legs unstuck, that is what I'm going to do.
skscuba - 4 / 5 - 28/05/2016
Well thought out
Too many unwanted items in the kit, which one has to pay for, i.e. legs & fittings not required, curved plinth not required as rectangular tray, plus other smaller items not required
kayg - 3 / 5 - 15/12/2015
Not pretty
functional, but has unsightly joins bridged by thick plastic spacers. Not very discreet