Gold Horizons Spa Hardness Plus is an effective product used for increasing calcium hardness levels within your spa water. Calcium hardness levels should be maintained within the recommended range of 100 - 200mg/l (ppm) to ensure that the spa and spa equipment is protected. More info:Gold Horizons Spa Hardness Plus Key Features/Characteristics Granular Ideal Calcium Hardness Range: 100 – 200mg/l When the calcium hardness level is below 100mg/l water can become corrosive leading to damage to spa finish and spa plant equipment. Spa Hardness plus is used to increase calcium hardness. Application Instructions 1. Before applying this product it should be pre-dissolved in a clean plastic container at a maximum rate of 10g per 0.2 gallons (1ltr) of clean cold water. Stir well to ensure the product is fully dissolved. Repeat application to achieve the total dose required – see table below for dose rates. It is recommended that the total treatment is split into three equal applications with a minimum of 1 hour between each. 2. After pre-dissolving add the resulting solution to the spa with the filtration system in operation. 3. Following the application the spa water may become cloudy so keep the filtration pump running continuously until it clears. 4. After treatment check the pH level and if necessary adjust to ideal range of 7.2 – 7.6. Dose rates Litres Gallons 1,000 220 1,500 330 - 92 - To increase calcium hardness by 10mg/l 15g 23g To increase calcium hardness by 25mg/l 38g 56g