CHARNWOOD PKSJ Woodworking Planer Blade Depth Setting Jig, Magnetic Holders

Our planer & thicknesser blade setting jigs offer a simplified and fast method to change the blades. The jigs can be used with most planers, thicknessers or combination machines. All you need is access to the cutter block, in most cases this means lifting up the planer beds or removing one of the tables completely.

The jigs are fitted with strong magnets which will clamp it to the cutter block. In the centre of the jig is a setting rod with another magnet for holding the tip of the blade, during setting.

All of our machines, and most other brands too, are supplied with a low cost blade setting tool. Whilst they are adequate, they are time consuming requiring great patience to get both ends of the blade equal. Tightening one bolt often inadvertently moves the opposite end of the blade.

On first use, the jigs are set and locked to the exact setting for your machine. Whenever fitting new or re-ground blades from then on, the setting will be saved on the jig and accurate height setting of the blades is made simple.

Charnwood PKSJ Specification

Minimum Cutterblock Diameter: 75mm

Maximum Cutterblock Diameter: 125mm

Number Of Blades: 2-4

Height Adjustment: 22mm

Increments Of Adjustment: 0.15mm

Supplied in a wooden storage case.

Please Note: The jigs are not suitable for use on planers with aluminium tables which are neither hinged or removeable. (Aluminium is not magnetic!)