CHARNWOOD W012 Bench Top Universal Router Table, Accepts All 1/4" Sized Routers

A router table will convert a hand held plunging router into a stationary tool which is safer to use and quicker to set up than using freehand. Ideally suited for all 1/4″ sized routers, this compact router table will perform a variety of jobs such as edge moulding, trenching and cutting tenons.

The side frames are steel with a smooth melamine faced MDF table across the top. The insert plate, which must be drilled to suit your routers fixing points, is made from a tough plastic with an aperture in the centre for the cutter.

The fence arrangement is simple and effective. The three clamps supplied as standard will hold the workpiece securely down against the table and up against the cutter leaving the operator to merely feed the timber through from right to left. A perspex guards protects the operator from flying chips and a dust chute is included for connecting to a vacuum or extractor. A sliding mitre fence, with a replaceable wooden face, completes the standard equipment.

The table can be used with any router which has a faceplate diameter of up to 190mm. This covers all 1/4″ shank routers and even some 1/2″ shank routers can be used.

The height under the table is 260mm. If your router is taller than this, you will need to make 2 runners to go underneath the side legs to lift the table up, to accommodate the extra height.

Supplied with tough plastic insert plate, adjustable fence with two replaceable wooden faces, horizontal feather board, two vertical clamps and sliding mitre fence.

W012 Specification

Table size 430mm x 400mm

Table height 290mm

Table thickness 20mm

Max. tooling diameter 35mm

Height Under Table 260mm

Maximum Faceplate Diameter 190mm

Mitre Guide Slot (W x D) 15mm x 8.5mm

Dimensions (WxDxH) 430mm x 400mm x 450mm

Weight 8kg

Warranty 1 Year